Search

Film Thickness Conversion Chart: Micron, Millimetre, Gauge and GSM

Why the same film has four thickness numbers

A buyer in Europe writes 0.25 mm, a converter in the US writes 10 mil, a printer in Asia writes 250 micron, and a purchasing sheet may ask for 340 gsm. All four can describe the same roll. Mixing them up is the most common reason a sample arrives at the wrong gauge, so it is worth fixing the arithmetic once.

The conversion rules

  • 1 mm = 1,000 micron (µm).
  • 1 mil = 25.4 micron = 0.0254 mm.
  • 1 gauge = 0.01 mil = 0.254 micron, so 100 gauge = 1 mil.
  • GSM (g/m²) = thickness in mm × density in g/cm³ × 1,000.

Chart for the gauges we ship most

  • 0.10 mm = 100 micron = 4 mil = 400 gauge ≈ 135 gsm (PVC)
  • 0.15 mm = 150 micron = 6 mil = 600 gauge ≈ 202 gsm (PVC)
  • 0.20 mm = 200 micron = 8 mil = 800 gauge ≈ 270 gsm (PVC)
  • 0.25 mm = 250 micron = 10 mil = 1,000 gauge ≈ 338 gsm (PVC)
  • 0.30 mm = 300 micron = 12 mil = 1,200 gauge ≈ 405 gsm (PVC)
  • 0.40 mm = 400 micron = 16 mil = 1,600 gauge ≈ 540 gsm (PVC)

The gsm column assumes rigid PVC at 1.35 g/cm³. Flexible PVC with a high plasticiser load sits lower, around 1.25, and TPU is about 1.20 while EVA is about 0.93. That is why gsm alone cannot define a film: 300 gsm of EVA is roughly 0.32 mm, but 300 gsm of PVC is only about 0.22 mm.

How to measure thickness on arrival

Use a micrometer with a flat anvil, not a caliper: a caliper squeezes the film and reads low on soft PVC. Take five readings across the width and five along the length, then average them. Embossed or matte surfaces read high at the peaks, so measure on a flat area or accept a slightly wider tolerance.

Our standard tolerance is plus or minus 5 percent, and plus or minus 3 percent for orders that specify it. A 0.30 mm roll can therefore legally measure 0.285 to 0.315 mm, which matters when the film has to pass a welding or sewing setting that was tuned on one sample.

FAQ

Is gauge the same everywhere? No. For plastic film, 1 gauge is 0.01 mil. In wire and sheet metal, gauge tables are different, so always confirm the unit with the supplier.

Can you produce to a gsm target instead of a thickness? Yes, but we will convert it to a thickness using the density of the grade and confirm both numbers on the quotation.

Which unit should I put on a purchase order? Millimetres or microns, plus the tolerance. Add gsm only as a secondary check.

Tell us the unit you work in and we will quote in the same unit, with the conversion shown.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top
WhatsApp us
Connect with XSMATECH
Facebook WhatsApp admin@xsmatech.com WeChat: 13826083558